I Pulled the Plug

It has been a long time coming, but I finally pulled the plug on the power co-op. I have long had enough solar power and more than enough inverter power, but battery was lacking and so was buried copper. Then there was the matter of the Round Tuit. I finally got around to it.

Batteries came to me last year. 3000-4000 amp-hours is a good place to be, but for how long? The batteries are strong, but they are about 8 years old. I am hoping for 15 years, but will be ever vigilant for battery opportunities.

There is all kinds of stuff buried in my yard and I am doubtful I can cut another trench without cutting some of the existing pipes and cables, so I sought to repurpose some of what I had. One cable, good for about 100 amps, was bringing DC power into the Zero Export Grid Tie experiment. That had been a successful project, but it just did not go far enough. That freed up the cable, some hardware and 16 golf car batteries.

I Pulled the Plug 1
Some of the Hardware That Came Out to Reclaim a cable for the New Transfer Switch Feed

Ok, remove the 2kw solar feed at the Solar Shed and install a 6 gauge jumper to the AC power bus. That end was done! Now, how to get the power into the house? I do not enjoy crawling under houses or boring holes through walls and floors, so maybe I could use an existing cable. Yes, I could!

Because in an earlier life I was running most of my house on a 5kw inverter, I had installed a lockout so that only one of the two central air units would run at a time. That left a 30 amp line from an external disconnect to the breaker box. With the aid of a very clever mechanism, shown below. I was able to turn my main breaker and that a/c breaker into a transfer switch. All I needed now was a 12′ whip cable to go from the a/c disconnect to the auxiliary power (aka “Generator”) disconnect. Pre-made cables are 6′, so I had to make a trip to Home Depot.

I Pulled the Plug 2
Convert your main breaker box into a transfer switch. A clever lockout device allows you to select grid or alternate power source. The main breaker is locked OFF and the top left breaker can be turned on to provide solar or generator power. Both breakers cannot be on at the same time. These transfer conversion kits are available on Ebay or Amazon for most panel models.

Some of you who are paying attention might note that I only have a 30 amp circuit here. To run the whole house? Nope. Having said that, though, the idea of Code making you put in service capacity of 200 amps and up is overkill.

Another breaker in the main panel has long gone to an “essential services” transfer switch. The load here started out with all the lights and the kitchen. (This was initiated while the house was under construction and a hurricane left the lines down for 4 days. The initial setup was a Trace PS2524 and 8 golf car batteries for backup. No solar.) A few outlets have been added so the TV and other paraphernalia , like a freezer and two more refrigerators can operate. This was all done on a 40 amp circuit, with ease. The two a/c compressors have no connection at all to the house or breaker box, powered directly from the solar shed. Inside, about the only things not on the essential line were the electric range, the air handlers and the laundry room. The only chance of popping the breaker on the new line would come if clothes were in the dryer when the stove was running on all burners. So far, so good. I just have to be careful about asking my wife NOT to cook. If it becomes an issue, I can bore some holes, crawl under the house and pull in a bigger cable.

I Pulled the Plug 3
A Pair of Sunny Islands, by SMA are my Primary Inverter

Another issue to watch in the coming months is inverter capacity. In addition to the house loads, the shop is charging 3 electric vehicles, running power tools and, in the Man Cave, there’s a home theater and more air conditioning. I have two power systems in parallel. A pair of SMA Sunny Island inverters producing 12kw is running the whole house and is the only inverter available to the new transfer switch. Another transfer switch in the Solar Shed lets me connect either the Sunny pair or a homebrew10kw inverter to the essential line. If capacity is an issue, I can run BOTH inverters, one to each circuit, for a total capacity of 22kw. If that should fail, there’s an automatic Kubota diesel generator and a manual Honda generator. The Honda will be living in the space vacated by the old grid tie system. Oh, yeah, and I can always flip back to the grid.

I Pulled the Plug 4
A Diesel, LP or Natural Gas Generator is a Good Backup. Gasoline is better than nothing.

Would I recommend such a screwy setup for you? No. Why do I have such a screwy system? Because it is an accumulation of things that have happened over 30 years, rather than the result of a plan. Capacity increased. Goals expanded. The next phase of work will be to clean it up and make it a bit more conventional.

I Pulled the Plug 5
Hubbell Connectors are the Standard in Generator Connection

What I would recommend to most anyone, is to have a transfer switch and generator circuit professionally installed. Make it 50 amps or better. That makes it easy to connect a conventional generator or your new and ever growing solar generator.

Something you need to do if you have solar or a generator is to make use of safety placards. The fire department does not like to spray water on a house full of live electrical conductors. I made some up with a home printer. You can get decal paper or use regular paper and weatherproof it by spraying with clear coat. Something like “House is Equipped With Automatic SILENT Backup Power Generator, Pull Disconnect Around Corner on Generator Shed.” is appropriate for my house.

I Pulled the Plug 6
Don’t Forget the Safety Placards. You can buy Premade Online or Custom Make Your Own

Two weeks in, I have not needed to reconnect or use the generator. There are compromises in how we operate, such as charging vehicles and drying clothes only during the daytime, but things are going well. I’ll write another time on compromises and you’ll see some of that in other articles, as well.

–Neal

2 thoughts on “I Pulled the Plug”

  1. When comes to professional DIY home, ranch, commercial, survival, probably ANY SOLAR FARMS and everything whatever else you seem to be able to do in general, Neal you are the MAN best DIY/Pro in the world and probably all practical levels and probably most professional levels ALL ONE GUY COULD DO You always blow me away ON EVERY ARTICLE YOUVE WRITTEN.

    I’ve said it once and I’ll say it again you guys that can build your own home, pump your own clean water etc., etc. etc. and mix in everything else given enough time are the backbone of freedom. Any solar industry guy and professional level would have to agree. I know I’m a little nutty but who cares as long as you get the job done and it’s smart to do, and helps this crazy world. I can’t tell you how grateful I am for all your posts.

    I don’t think enough people are aware of your skill, knowledge and wit. Help me help you get on all the solar blogs and social solar media especially like Northern Arizona Wind and Sun they have a great

  2. Northern Arizona Solar Forum
    Is one of or the best Solar Forums on the internet. I went to high school with the owner. Unless he sold it.

    But spread the word about Neals technical blog on sunelec.com as well. What a great writer, brilliant and hilarious at the same time. The owner’s blog isn’t all that bad, he just doesn’t correct all his typos.

    Here’s. Shout out to David Katz, John what’s his name oh yeah Schaefer who started Real Goods, Allan King, and Jeorge Newberry in Big Pine Key, to mention a few. What the hell and to my oldest brother Bill Kimball who hasn’t spoken to me in 30 years.

    Be sure to read the sunelec.com technical blog by Neal Collier and mine John’s solar blog just Google it. Check out our Photos too.

    JK

Leave a Reply to John Kimball Cancel Reply

Your email address will not be published. Required fields are marked *

Open chat
1
need help?
Scan the code
SunElectronics
Hello 👋
Can we help you?